☰ 🔍
🖊️Ask a Question
Electrical Engineering

By 00 probe in AT weld testing with normal gain setting. (i) Area below N.axis can be tested. (ii) Area below N.axis can not be tested.* (iii) Only web below N.axis can be tested. (iv) All above are correct.

by 0 views
By 00 probe in AT weld testing with normal gain setting.
(i) Area below N.axis can be tested.
(ii) Area below N.axis can not be tested.*
(iii) Only web below N.axis can be tested.
(iv) All above are correct.
0 like 0 dislike

1 Answer

by
(ii) Area below N.axis can not be tested.*
0 like 0 dislike

Related questions

by ayush dekate asked Jul 31, 2021 0 views
Side looking 700 2MHZ probe is tested for detecting. (i) Flaw in head (ii) Flaw in web (iii) Half moon crack in flange.* (iv) For all above.

Side looking 700 2MHZ probe is tested for detecting. (i) Flaw in head (ii) Flaw in web (iii) Half moon crack in flange.* (iv) For all above.
Answer : iii) Half moon crack in flange...

View solution
0 like 0 dislike
1 answer
by ayush dekate asked Jul 31, 2021 1 view
On a branch line one new AT Weld with 00 probe shows a signal of 58 is. (i) DFWO* (ii) DFWR (iii) IMRW (iv) OBSW

On a branch line one new AT Weld with 00 probe shows a signal of 58 is. (i) DFWO* (ii) DFWR (iii) IMRW (iv) OBSW
Answer : i) DFWO*...

View solution
0 like 0 dislike
1 answer
by ayush dekate asked Jul 31, 2021 0 views
During periodic testing of an AT weld with 700 probe, a bunch of moving signals of less than 40% but more than 10% is observed in the head of weld, the joint will be. (i) Good joint.* (ii) DFWR (iii) DFWO (iv) OBSW

During periodic testing of an AT weld with 700 probe, a bunch of moving signals of less than 40% but more than 10% is observed in the head of weld, the joint will be. (i) Good joint.* (ii) DFWR (iii) DFWO (iv) OBSW
Answer : i) Good joint.*...

View solution
0 like 0 dislike
1 answer
by ayush dekate asked Jul 31, 2021 0 views
450 probe is used for detecting defect in; (i) FB weld (ii) AT weld (iii) FB weld, AT weld & SEJ (iv) All above*

450 probe is used for detecting defect in; (i) FB weld (ii) AT weld (iii) FB weld, AT weld & SEJ (iv) All above*
Answer : (iv) All above*...

View solution
0 like 0 dislike
1 answer
by ayush dekate asked Jul 31, 2021 0 views
USFD testing of new AT weld will be done by ? (i) JE/SSE sectional (ii) Incharge SSE (iii) USFD machine operator* (iv) None of the above

USFD testing of new AT weld will be done by ? (i) JE/SSE sectional (ii) Incharge SSE (iii) USFD machine operator* (iv) None of the above
Answer : (iv) None of the above...

View solution
0 like 0 dislike
1 answer

50.5k questions

47.1k answers

240 comments

7.0k users

© 2025 Question Answer