☰ 🔍
🖊️Ask a Question
Electrical Engineering

Defect of High joint is due to ? (i) Early trimming of weld (ii) Excess provision of height during alignment.* (iii) Early grinding of weld (iv) None of above

by 0 views
Defect of High joint is due to ?
 (i) Early trimming of weld
 (ii) Excess provision of height during alignment.*  (iii) Early grinding of weld
 (iv) None of above
0 like 0 dislike

1 Answer

by
(ii) Excess provision of height during alignment.
0 like 0 dislike

Related questions

by ayush dekate asked Jul 31, 2021 1 view
Defect of low joint is due to? (i) Excess height (ii) Early trimming of weld (iii) Early grinding of weld (iv) Nil/Less provision of height during alignment.

Defect of low joint is due to? (i) Excess height (ii) Early trimming of weld (iii) Early grinding of weld (iv) Nil/Less provision of height during alignment.
Answer : (iv) Nil/Less provision of height during alignment....

View solution
0 like 0 dislike
1 answer
by ayush dekate asked Jul 31, 2021 0 views
Defect of cracks in weld is mainly due to? (i) Early opening of mould.* (ii) Early trimming of weld (iii) Early grinding of weld (iv) None of above

Defect of cracks in weld is mainly due to? (i) Early opening of mould.* (ii) Early trimming of weld (iii) Early grinding of weld (iv) None of above
Answer : (i) Early opening of mould.*...

View solution
0 like 0 dislike
1 answer
by ayush dekate asked Jul 31, 2021 0 views
Defect of lack of fusion is mainly due to? (i) Improper heating.* (ii) Improper Gap (iii) Improper grinding (iv) None of above

Defect of lack of fusion is mainly due to? (i) Improper heating.* (ii) Improper Gap (iii) Improper grinding (iv) None of above
Answer : (i) Improper heating.*...

View solution
0 like 0 dislike
1 answer
by ayush dekate asked Jul 31, 2021 0 views
Trimming of AT weld should be done by ? (i) Chisel (ii) Trimmer* (iii) Both (iv) None of the above

Trimming of AT weld should be done by ? (i) Chisel (ii) Trimmer* (iii) Both (iv) None of the above
Answer : ii) Trimmer*...

View solution
0 like 0 dislike
1 answer
by ayush dekate asked Jul 31, 2021 0 views
In how many time final grinding should be done of new AT weld ? (i) Just after the welding (ii) After 8 hrs of welding (iii) With in 24 hrs* (iv) None of the above

In how many time final grinding should be done of new AT weld ? (i) Just after the welding (ii) After 8 hrs of welding (iii) With in 24 hrs* (iv) None of the above
Answer : iii) With in 24 hrs*...

View solution
0 like 0 dislike
1 answer

50.5k questions

47.1k answers

240 comments

7.0k users

© 2025 Question Answer